Liveo™ MG 7-9800 Soft Skin Adhesive Kit (A & B)

How to use

Mixing:

Thoroughly mix the desired amount part A and part B in a 1:1 ratio by weight. Static mixers are recommended mixing tools. During mixing, care should be taken to minimize air entrapment. Airless mixing, metering and dispensing equipment is recommended for large production processing.

De-airing:

If a void-free finished part is desired, the entrapped air must be removed from the mixed materials. Exposure to a residual pressure of 711 Torr for several minutes is typically adequate. The vessel containing the material should be at least four times the volume of the mixture to allow for expansion.

Coating:

The suggested coating method is knife over roll. Suggested coating thickness is from 0.1mm to 0.5mm (approximately 100g/m²-500g/m²). Thicker coats can be applied if more elastomeric properties are desired.

Curing:

The cure reaction will begin once the two parts have been mixed. The initial viscosity will at least double within 1 hour at 25°C. The cure reaction will occur at room temperature; however heating will accelerate the process.

Cleaning:

To remove uncured adhesive, Liveo™ Q7-9180 (0.65cst) Silicone Fluid, isopropyl alcohol, ethyl acetate, xylene or heptane can be used. When the adhesive is cured, the greater part should be removed by mechanical means and only the remaining material should be removed with one of the aforementioned solvents.

SAFETY WARNING

Before handling, please consult the corresponding material safety data sheets. These are available upon request or can be downloaded from our DuPont website: www.DuPont.com